Skip to main content

HIAD Quality Indicator: 3


An explosion and fire occurred at a reciprocating recycle hydrogen compressor during commissioning of a new Diesel hydrotreatement Unit. It happened during the reactor pre-sulphidisation step, when…

This incident occurred at a hydrogen refuelling station with on-site hydrogen production based on reforming of city gas and natural gas. The part affected was a coil in the heat exchanger…

Release from a compressed hydrogen bottle used to fill balloons. The release was followed by ignition and perhaps fast deflagration. Nine people affected, including the operator of the bottle.
The event occurred in the continuous casting of hot metallic melt of the plant. Cooling water leaked through a crack in the cooling water inlet pipe of a secondary cooling line and directly into the…
The event took place at the metal sheet pre-heating oven of a galvanization unit. This was using a mixture of hydrogen and nitrogen to form a reducing atmosphere and avoid oxydation of the metallic…
The incident occurred in a building containing the residues of the production of sodium, lithium and chlorine. The alarm was given by an employee who heard detonations coming from the building. A few…
The sodium chlorate production unit had restarted after a maintenance shutdown phase. The mercury cells had been under nitrogen flushing since the beginning of the shutdown to avoid the presence of…
Hydrogen fire at a chlorine chemical production plant (Seveso-classified) Hydrogen ignited in a chlorine electrolyser unit. The facility was shutdown when the incident occured. The staff of the unit,…
A leak occurred while loading a trailer carrying hydrogen gas cylinders. The trailer was loaded with 4 bundles of 60 cylinders at 200 bar which were beeing refilled. The leak was heard, and an…
A lorry loaded with gaseous hydrogen cylinders caught fire and shut a motorway. No one has been injured.
The incident occurred at the hydrocracker unit, which was being shut down for maintenance and the reactor was in a hydrogen purge cycle. A hydrogen gas line failed at a weld. The line was at 3000 psi…
A hydrogen leak occurred on the hydrogen line of a hydro-desulphurisation unit, followed by ignition . The failure was located on a supply manifold of the unit at a support beam. The unit was shut…
Three workers were working in the sulphur recovery unit (SRU), trying to restore the hydrogen flow. The workers were trying to isolate the cause of a flow problem: hydrogen was entering the…
The regular maintenance of the hydrogen production equipment had been completed and the plant was about to start up. At this point, fluid mainly composed of hydrogen was sent via a pipe to the…
The release occurred on a pipeline inside a steam cracking unit located between two hydrogenation units. The gaseous mixture transported through this line (2" diameter, 30 bar, 40°C) was composed of…
The hydrogen leak occurred on a lorry travelling on a motorway. According to Highways England the vehicle was carrying nine cylinders of gas, one of which had a crack and was leaking. The only way to…

Hydrogen as carrier gas was provided to a reactor gas chromatograph by several compressed hydrogen bottles. The bottles emptied rapidly, but the loss of carrier gas could only be detected when the…

Following the first flight of the Montgolfier brothers, the first severe accident with hydrogen on a Montgolfier-balloon occurred in 1785, when trying to cross the Channel from France to England. Two…
The event occurred at a pit furnace for metal component treatments. The hydrogen feed system for the furnace developed a leak, located on the hydrogen dryer inside a shack attached to a building. The…
The charge pump on a hydro-desulphuriser unit tripped. The charge flow control valve then opened wide on low flow. The high pressure hydrogen supply to the unit flowed backwards through a faulty non…