Skip to main content

HIAD Quality Indicator: 3


A leak occurred on hydrogen compressor in a plant of production of renewable hydrogen. A pipe on the condensate purge circuit of the compressor ruptured, releasing hydrogen and producing a noise…

A liquid hydrogen tanker was returning to base terminal after having delivered at a space centre, when the driver noticed excessive venting of hydrogen gas vapour from the rear . The driver pulled…

An empty liquid hydrogen tanker was returning to home terminal after having delivered at a space centre. A motorist passed by and pointed to the rear of the tanker. The driver stopped the vehicle…

A liquid hydrogen tanker-tractor was travelling on a highway, when the drivers noticed vapour coming from the tank. They pulled the vehicle safely off the road and discovered that the vapour was…

The leak was located at a tube valve at the rear of the semi-trailer. It occurred at the beginning of packaging the semi-trailer, which was at a pressure of 50 bar. The expert appraisal showed…

During the filling of a hydrogen tube trailer, a hissing sound alerted the staff at an industrial gas manufacturing plant to a leak. The pressure in the tube trailer being filled was close to 200…

The driver of a liquid hydrogen tanker noticed a small vapour plume in his mirror while driving. The driver stopped and found the packing nut had loosened on the vapour recovery valve causing the…

This event occurred at a depot site with 20 fuel cell buses are operated by a local bus company. A hissing sound was heard coming from a hydrogen tank at the refuelling facility, and the local fire…
The incident occurred during the start-up after a routine repair of the refinery's heavy oil hydrodesulfurization system. A valve at the inlet pipe of a high-temperature and high-pressure separation…
A hydrogen leakage occurred in the ammonia workshop of a plant manufacturing nitrogen products and fertilizer (classified SEVESO high threshold). It was detected by an operator in charge of safety…

The event occurred during a pressure testing of a LH2 pump discharge system. A weld joint failed at an internally tied bellows. The weld failed at 1100 psi (ca. 76 bar) while the test pressure…

During transfer of LH2 from a 200,000 gallon (760 m3) storage vessel to a road trailer, loss of vacuum was detected due to a crack in the outer vessel. The crack was located below an elbow of the…

A liquid hydrogen tanker was travelling on a highway, when it overturned. The product remained secure within the trailer and there was release to atmosphere during the accident. During the clean…

A LH2 hydrogen went off road and overturned. There was no spillage. All regulatory agencies were notified and the road was closed for an extended period of time.

A liquid hydrogen tanker (with a water capacity of 2000 l) was passing a highway interchange, when the safety valve of the tank activated, releasing hydrogen gas. The drivers stopped first on the…

A lightning strike ignited the hydrogen exiting a stack in a chemical factory. The hydrogen, produced by the chlorine electrolysis cells, was conveyed to the stack when the manufacturing unit using…

While on a highway, the driver of a liquid hydrogen tanker was notified that vapour was coming out of the back of the trailer. The driver pulled into a safe haven to investigate. After opening the…

During the transit of 10 000 gallons (ca. 39000 l) LH2 transport vessel, the venting rate became extremely high . The annular vacuum appeared to be lost showing large patches of condensed water at…

The drivers failed to stabilise the tank pressure after having delivered the liquid hydrogen. Therefore they had to stop and perform a manual vent on journey back to the base. [Zalosh and Short,…

A pressure build-up in the tank of a liquid hyrogen tanker caused the drivers to vent 6000 cu ft of hydrogen to reduce the pressure. [Zalosh and Short, 1978]