- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
During the J-2 engine testing program, the engine start tank was pressurised. The pressure raised to an excess of 1500 psi (ca. 105 bar). The venting of the tank was attempted but remained…
Following loading of propellant run tanks, the insulation jacket (filled with perlite) on the conmon vent and pressurisation line for the LH2 storage tank burst. [Ordin, NASA (1974)]
A collision between two vehicles occurred at the corner of two streets. One vehicle was a fuel cells and hydrogen vehicle (FCEV), the other was a conventional one. Its driver incorrectly did not…
During preparation of a spacecraft LH2 tank in an environmental test chamber, a liquid hydrogen fire occurred in the chamber. The tank was being "topped off" at the time. Damage was…
A fire started in the night on one of the fuel cells and hydrogen bus of a garage of a public transport company. There were seven buses parked on a parking lot outside. 6 buses were destroyed by…
This incident happened during a test of a hydrogen engine prototype vehicle, equipped with on-board liquefied hydrogen storage. The hydrogen gas leaked from a hose joint of a flexible pipe in the…
This event occurred when dismantling the cryostat. While a hot air dryer was being used to free a coupling in a hydrogen cryostat, a flash fire occurred. [Ordin, NASA (1974)]
During a cryo-irradiation testing, a Dewar failed or leaked hydrogen into the atmosphere, causing a fire. The Dewar's were nitrogen-walled LH2 vessels to contain metal samples for testing. In…
The event occurred when attempting to replace a rupture disk in a LH2 vessel. Hydrogen gas was released and ignited. In fighting the fire, liquid nitrogen was sprayed onto a second LH2 vessel…
This incident occurred at a hydrogen refuelling station with on-site hydrogen production based on reforming of city gas and natural gas. The part affected was a coil in the heat exchanger…
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.