Skip to main content

Regions and Countries: United Kingdom


An employee used a small industrial vacuum cleaner on an unnamed process. During this process, hydrogen gas built up from a reaction between sulphuric acid and aluminium swarf. When the vacuum…
A hydrogen explosion happened at a chemical plant in Cheshire, UK where 18 tons of hydrogen gas went up. The firefighters were on the scene tackling the fire quickly and efficiently.
Explosion within a blast furnace occurred at the plant manufacturing iron. The event occurred at one of the blast furnace of the plant, which exploded. The explosion was so powerful that the entire…
A wash machine was being used to clean aluminium trays with burnt on product. The auto wash in normal situations cleaned steel trays, and not aluminium. The cleaning fluid contained sodium hydroxide…
Explosion in generator area, thought to be hydrogen leak as a result of radial lead seal failure. Extensive plant damage.
The explosion occurred at the second floor of university building, where a postdoc researcher was conducting a chemical experiment using hydrogen gas in the laboratory. First a chemical fire started…
The explosion was caused by the ignition of hydrogen during reaction with sodium metal. The Chemistry Department routinely dried solvents using metallic sodium. This leaves an excess of sodium metal,…
An explosion occurred in an electrostatic precipitator whilst it was being accessed for maintenance. The explosion caused an inspection hatch cover, which had been unbolted, to be blown off and…
An explosion occurred in the teat treatment workshop of this site. The explosion was centred in the electrical control panel of the High Velocity Oxy Fuel (HVOF) thermal spraying equipment. The…
In a chemical plant, a 1750 m³ tank containing an ammoniac solution exploded. The anchorage of the tank was ripped, the tank lifted on one side and crashed against the retention wall, which was…
The balloon had a 3. 5m external diameter envelope made of anti-tear fabric (same techniques used in full sized balloons of the same company). The inner balloon was a meteorological balloon made of…
The accident occurred in a disposal storage for contaminated waste, consisting in a 65-metre shaft flooded with seawater. At the origin of the explosion was the reaction with water of at least two…
The accident occurred when a welder belong to a sub-contractor company was working on tank roof. The zeolite crystallisation tank was being cleaned out with approx. 20% sulphuric acid. It was not…
A process operator was working on a hydrogen tank in a mechanical workshop. The goal of the onoging operation was the removal of the collar from a hydrogen cylinder. An electric crosscut saw was used…
A dual phase hydrogen tanker was expected to refill the storage of a refuelling station for buses. Due to the failure of the a bolt of the tanker pump, the refuelling could not take place. This…
An operator had just replaced the ignition port cover on a hydrochloric acid plant burner. Normal start-up was continued by closing the drain valve in the product run off line and opening the…
This incident occurred in the turbine compressor system. A severe hydrogen ingress into the stator coolant system resulted in a fire in the stator coolant head tank (ignition source unknown). No…
The compressor-turbine unit tripped while on on-load, due to a serious fire between alternator and one of the bearing. The failure of a generator slip ring and of the hydrogen seal caused the leak of…
The explosion occurred in the condenser area of a steam turbine, two hours after the unit tripped due to a stator earth fault. The stator earth fault had damaged two hydrogen cooler tubes, which…
Ejection of rotor wedge material lead to vibration induced failure of components, including hydrogen seals. Serious fire resulted from hydrogen leakage, which subsequently lead to an oil fire.…