Explosion when working on a hydrogen cylinder
A process operator was working on a hydrogen tank in a mechanical workshop. The goal of the onoging operation was the removal of the collar from a hydrogen cylinder. An electric crosscut saw was used to make two diagonal cuts in the collar of the cylinder before removal of the collar with a hammer and chisel. An angle grinder was also occasionally used when a collar was proving difficult to remove. The investigation found out that the purging of the cylinder had not been performed, or performed only partially, leaving high concentrations of hydrogen. Sparks from the cutting process caused ignition of hydrogen present in container.
Event Initiating System
Classification of the Physical Effects
Nature of the Consequences
Cause Comments
INITIATING cause: Rest hydrogen in cylinder while starting mechanical work ROOT CAUSE: no purging, thus failing to execute correctly procedures, or shortcoming in procedure, and lack of risk management throughout the process.
