Skip to main content

HIAD Nature Event - Release Type: Mixed


A fire developed on a mathanation reactor. The methanation reactor vessel was found to be deformed and had a 3-4 inch rupture at a position corresponding to the top of the catalyst bed. It is thougth…

Break of pipeline in oil cracker, resulting in a continuous release in partially confined atmosphere.

A major leak occurred at the outlet of the diesel hydrodesulphurisation furnace in a refinery. The furnace was just restarting. The released gaseous product ignited, and the alarms of the temperature…
In a petrochemical plant, a fire occurred on the methanation unit (95% H2 + 5% CO -> CH4 + H2 + H2O) of a steam cracker. A seal break on a flange of the circuit caused of the accident. No…

A tube ruptured in the charge heater ('fired heater') of a desulphurisation reactor due to a blockage caused by accelerated coking. Flames spread over an area of some 100 feet outward…

This incident occurred a product purge vessel flange during planned maintenance activities on a chemical plant. The vessel had the function to collect unreacted gases from a polyethylene…

A fire broke out affecting the heavy fuel purification plant of the refinery. The incident could have originated by the failure of one of the following plant components: - pipes leading to the…

The incident occurred at the hydrocracker unit of a refinery. A mixture of hydrogen and hydrocarbon gas was accidentally released. The flammable gas formed a vapour cloud that ignited, resulting…

A gas leak containing hydrogen and hydrogen sulphide (H2S) occurred at the upper isolation valve located at a high-pressure separator (300 bar). This unit spearates the process gases from process…
A compressed gas spherical vessel failed along the along the weld, releasing the whole content, consisting in a H2-CH4-rich mixture (54%, 26%). The cause was stress corrosion accelerated by hydrogen.
Three workers were asphyxiated when argon and hydrogen gas leaked from pipes they were installing on an aromatics plant being built on a cracking complex.
During a routine inspection, a flame was observed at the bottom flange of a reactor in a refinery. Few moments later, sensors near the leak detected a rise in temperature. The facility was shut down…
During a work tour on a refinery, an employee noticed a fire at the level of a flange at the inlet of the grille of an exchanger, located at the outlet of a reactor of the catalytic reforming unit.…
The leak ignited at the seal located between the bottom and the body of a heat exchanger of a desulphurization unit of a refinery. The fire is alimented by the leaking fuel under pressure for about…
A fire, fuelled by a mixture of gasoline and hydrogen, occurred on a heat exchanger located at 15 m height in a gasoline processing unit of a refinery. The operator triggered the emergency plan. Site…
In a petrochemical plant, a gas mixture at 270 bar made of 75% hydrogen (H2) and 25% methane (CH4) leaked through the bottom valve of a dryer of a resin production unit. After detection of the leak,…
An accident occurred before the start of a scientific demonstration at a school. Part of the school demonstration was about hydrogen-oxygen balloons. To prepare for the demonstration, the…
The accident occurred at a distillate dewaxing Unit (MDDW) of the refinery, during the operation of regeneration of the catalyst. To perform this operation, both temperature and pressure have to be…
The event occurred in the continuous casting of hot metallic melt of the plant. Cooling water leaked through a crack in the cooling water inlet pipe of a secondary cooling line and directly into the…
The event took place at the metal sheet pre-heating oven of a galvanization unit. This was using a mixture of hydrogen and nitrogen to form a reducing atmosphere and avoid oxydation of the metallic…