- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
An accident occurred between a tractor and an hydrogen and fuel cells train at an unguarded level crossing. The driver of the tractor, which had also a trailer, apparently failed to see the train.…
[Note HIAD validator: this an incident where a hydrogen system was affected, as effect of the initiating event, overpressure of LH2 tank with helium, but it is not a LH2 incident]. The second…
A stainless steel manifold ruptured during experimental operation. The manifold was made of stainless steel and had a diameter of three inch (7. 5 cm). The hardware was off-the-shelf, slightly…
After a test of a LH2 vessel, during the warm up phase, the plan was to dispose of the hydrogen through the vent system. However, a leak to atmosphere occurred. This was due to a blind flange…
During initial resting at a liquid hydrogen bubble chamber facility, an explosion occurred shortly after opening a high pressure hydroger line. The explosion was assumed to have taken place in the…
The incident occurred at end of a hydrogen fuel pump test, when large volume of gaseous hydrogen was vented off. An explosion occurred at or near the top of the vent stack, with damage to stack…
A large quantity of hydrogen was being vented to atmosphere during pre-chill operations. Normal pre-cooling time was about 45 minutes, but due to technical problems, the pre-cooling continued for…
The event occurred during the testing of a LH2 pump. When the air turbine pump drive was initiated, the cool down of pump loop was underway, and the speed had increased to design condition and…
During operation of a gaseous hydrogen purifier system, an explosion occurred when the valves were actuated to admit hydrogen. The purifier consisted of a precooler coil immersed in liquid…
This event occurred at after the testing of a LH2 tank. The LH2 was then removed and the tank purged with helium gas for more than 4 hours. A flange was then removed to allow for insertion of…
After cooldown of a LH2 system, the operator noticed cold gas issuing from a small hole in a flexible section of the vent line. Subsequent examination revealed that a deflagration had taken place…
During general repair and equipment replacement on a liquid oxygen-liquid hydrogen Saturn test facility, a section of the 24-inch GH2 vent line ruptured. An explosion occurred causing extensive…
During welding of a pipe to an existing header vent system, hydrogen gas was ignited. The adjacent vessels and lines were inerted with helium and a hydrogen detection check did not indicate…
A liquid hydrogen system exploded and burned during fill operations due to inadequate purging after the previous operation. [Ordin, NASA (1974)]
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.