- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
The event occurred when attempting to replace a rupture disk in a LH2 vessel. Hydrogen gas was released and ignited. In fighting the fire, liquid nitrogen was sprayed onto a second LH2 vessel…
While welding cable suspended over stainless steel H2 instrument line, two holes were burned through tubing. A hissing sound was heard and operator closed a valve. In feeling for gas leak which…
A hydrogen fire broke out at the aft end of the orbiter connected to the LH2 onboard tank of a space shuttle. This happened during the abortion of the launch, occurred due to another cause, the…
The event occurred during the fuelling process of the primary fuel tank of the core stage of a moon rocket. The initial slow-filling phase was terminated, and personnel had just started the fast…
The release occurred during refuelling of the mobile storage system. This operation was part of a series of tests aiming at verifying the tightness of the system. When opening a valve to connect…
A large hydrogen gas leak from a dewar resulted when bolts holding fitting the top of the tank was loosened. The fitting contained instruments. On loosening the third bolt, hydrogen gas excaped…
A hydrogen leak occurred during refuelling of a fuel cell-powered lift truck. The forklift was depowered. This was the first refuelling after the replacement of the in-tank shutoff solenoid valve…
A leak occurred at the fill valve of a LH2 vessel. With the tank pressure at about 100 psi a leak was noticed. The area was cleared and the vessel was emptied by remote controls. [Ordin, NASA…
In 1990 the Space Shuttle fleet was grounded for several months by an elusive hydrogen leak occurring during the procedure of fuelling of the liquid hydrogen tank of a space shuttle. The Columbia…
The event occurred during a pressure testing of a LH2 pump discharge system. A weld joint failed at an internally tied bellows. The weld failed at 1100 psi (ca. 76 bar) while the test pressure…
During a welding operation on a LH2 fill line it was discovered that LH2 was still in the tank although it should have been drained. Hence the potential for a major explosion existed. [Ordin, NASA…
The second stage of the Saturn V (S-II-T) was under full-duration static test, when one fire near LH2 valves of the LH2 tank and another in the engine area caused the automatic termination of the…
During the pre-launch checkout, a check valve failed in the "open" position and an accidental venting of liquid hydrogen occurred. The event caused an unscheduled check and replacement…
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.