Skip to main content

HIAD Events

This data is from the European Hydrogen Incidents and Accidents database HIAD 2.1, European Commission, Joint Research Centre.



During simultaneous hydrogen venting operations of two hydrogen trailers adjacent to one another, hydrogen was ignited at one, and then the fire ignited the hydrogen venting from the other trailer…

While filling a 9 litre gas cylinder with pressurised hydrogen in the hydrogen storage area, a blast occurred which destroyed the low pressure gauge, followed by a jet fire which damaged the surface…
A man was burned when a fire broke out as a hydrogen cylinder was being changed in a governmental research centre. It was reported that the fire was started by a spark from a wrench. The sprinkler…

A small fire developed at the connection hose between the LH2 delivery trailer and the customer stationary tank. The driver intervened to isolate the hose first on the delivery side, and then at…

While welding cable suspended over stainless steel H2 instrument line, two holes were burned through tubing. A hissing sound was heard and operator closed a valve. In feeling for gas leak which…

This incident occurred a product purge vessel flange during planned maintenance activities on a chemical plant. The vessel had the function to collect unreacted gases from a polyethylene…

While a LH2 barge was being disconnected from dock, a flash occurred in the vent stack. No damage occurred but potential existed for major damage. [Ordin, NASA (1974)]

A triangle flask exploded during a science-class experiment where diluted hydrochloric acid was made to react with zinc to generate hydrogen, at a junior high school. Injures were caused by glass…
A hydrogen and batteries driven aircraft was forced to land after a flight incident. According to the aircraft company the aircraft was forced to an emergency landing, but landed normally on its…

A liquid hydrogen tanker was returning empty to the home terminal after delivery to a customer. At a stop, the drivers executed a visual inspection of the vehicle and noticed an accumulation of…

According to the media news, the accident involved an explosion of a fuel cell driven forklift during driving, resulting in an employee's death and 6 light injured other employees. The fire did not…
A fire broke out affecting the heavy fuel purification plant of the refinery. The incident could have originated by the failure of one of the following plant components: - pipes leading to the…
In a plastics production plant, a pallet containing 7 cylinders of nitrogen and 1 cylinder of hydrogen fell from a truck traveling in a logistics zone. The driver stopped the vehicle, cut off the…

The incident occurred at the hydrocracker unit of a refinery. A mixture of hydrogen and hydrocarbon gas was accidentally released. The flammable gas formed a vapour cloud that ignited, resulting…

A gas leak containing hydrogen and hydrogen sulphide (H2S) occurred at the upper isolation valve located at a high-pressure separator (300 bar). This unit spearates the process gases from process…
A compressed gas spherical vessel failed along the along the weld, releasing the whole content, consisting in a H2-CH4-rich mixture (54%, 26%). The cause was stress corrosion accelerated by hydrogen.
Three workers were asphyxiated when argon and hydrogen gas leaked from pipes they were installing on an aromatics plant being built on a cracking complex.

A dispenser hose failed at a hydrogen refuelling station. It ruptured with a sidewall burst, approximately 30 cm from the crimped end fitting. The hose had experienced a total of aproximately 300…

The incident occurred while transferring gaseous hydrogen from a tube trailer to a customer stationary supply system. The transfer hose ruptured and released hydrogen which ignited explosively.…

During a routine inspection, a flame was observed at the bottom flange of a reactor in a refinery. Few moments later, sensors near the leak detected a rise in temperature. The facility was shut down…
During a work tour on a refinery, an employee noticed a fire at the level of a flange at the inlet of the grille of an exchanger, located at the outlet of a reactor of the catalytic reforming unit.…
A diesel and gas leak (H2, H2S, CH4) occurred in a hydrodesulphurization unit (2,200 t/d). The leak location was on one of the boiler valves of the stabilization column. The released mixture (390 °C…
The leak ignited at the seal located between the bottom and the body of a heat exchanger of a desulphurization unit of a refinery. The fire is alimented by the leaking fuel under pressure for about…
Hydrogen ignition during welding on a VSC-24 spent fuel cask Pursuant to 10 CFR 72. 210 - fuel in an independent spent fuel storage installation at its Point Beach Nuclear Power Plant. The inspection…

Hydrogen was accidentally released into the compressor room of a hydrogen refuelling station. The fixed gas detector in the compressor room issued a value of 48% vol. of he Low FLammability Level,…

A hydrogen explosion occurred in a 5-tonne stainless steel pressure vessel, while two electro-polisher workers where electropolishing internal surfaces. The cause is believed to be the build-up…

A fire, fuelled by a mixture of gasoline and hydrogen, occurred on a heat exchanger located at 15 m height in a gasoline processing unit of a refinery. The operator triggered the emergency plan. Site…

The incident occurred at a reactor vessel of a naphtha hydrotreater unit. The vessel operated at around 25 bar and 140 C. A 1. 5-meter crack opened up in the reactor vessel close to welded vessel…

In a petrochemical plant, a gas mixture at 270 bar made of 75% hydrogen (H2) and 25% methane (CH4) leaked through the bottom valve of a dryer of a resin production unit. After detection of the leak,…
A Worner 1000 STU gas balloon, of German registry D-OAGH, piloted by a commercial pilot was substantially damaged during landing, when the hydrogen-filled envelope came in contact with a power line,…