Skip to main content

HIAD Causes: Installation Error


[NOTE of HIAD Validator: the sources are not completely clear in describing the system involved in this incident ; the following is the most plausible option ] The explosion happened in two hydrogen…
The event occurred in a support building at a test stand complex. The explosion destroyed two support buildings and severely damaged a large amount of equipment. No one was injured. Gaseous hydrogen…
An open backed truck was delivering various to various sites industrial gases, among which hydrogen. At the site of the explosion a rack of argon gas bottles was being delivered to a laboratory in…
The event early on a Saturday morning, when the plant was thus practically empty. Nevertheless, the chronology of the accident can be reconstructed from the testimonies of the few operators who were…

The incident occurred at a hydrogenation reactor producing alcohols. At the time of the fault, the plant was in normal operation. A sudden leak of hydrogen occurred on the flange of the upper…

The regular maintenance of the hydrogen production equipment had been completed and the plant was about to start up. At this point, fluid mainly composed of hydrogen was sent via a pipe to the…

A truck transporting hydrogen and oxygen cylinders collided with a passenger vehicle at an intersection and overturned, causing all cylinders containers to fall onto the road. Gas leaked from four…

The burst disc activated prematurely on a small hydrogen tube trailer. The pressure at which the activation occurred was between 80 and 100 bar (1200 and 1500 psig). The design activation pressure…

The release occurred during refuelling of the mobile storage system. This operation was part of a series of tests aiming at verifying the tightness of the system. When opening a valve to connect…

A hydrogen leak occurs at on the hose connection of a tube trailer being loaded into an industrial gas company. Alerted by the noise, the driver of the vehicle gave the alert. Firefighters from the…

During a transfer of liquid hydrogen from a commercial tanker to a stationary receiving vessel, a leak developed in the bayonet fitting at trailer-vessel connection. The leak produced a hydrogen…

This accident occurred at the unit producing synthetic adhesives by adding hydrogen to petroleum resin under high temperature and pressure. Hydrogen was added to the reaction via a supply pipe at the…

A CGH2 trailer-tractor arrived at a customer’s site for delivery. When stopping at gate and coming out of the cab, the driver noticed a noise coming from the rear of the trailer. The driver opened…

A tube trailer carrying compressed hydrogen was travelling along a city road, when the drivers heard an abnormal sound from behind. They stopped and discovered that hydrogen was leaking from the…

The accident occurred during the filling of hydrogen into a fuel cell vehicle (FCV) at a hydrogen station. The gas detector in the dispenser detected a leak, and the equipment was shut down. A…

A hydrogen leak occurred during refuelling of a fuel cell-powered lift truck. The forklift was depowered. This was the first refuelling after the replacement of the in-tank shutoff solenoid valve…

The leak occurred on the compressor of a hydrogen testing laboratory. The location of the leak in the cylinder cap of one of the ultra-high-pressure hydrogen compressor unit. The hydrogen gas…

This near miss occurred at an airport's hydrogen refilling station. At 7:35, a hydrogen leak was detected by hearing whistles in the near of a pipe. The operators warned the airport firefighters ten…
The incident occurred at an alkaline electrolyser in a renewable hydrogen production plant. It consisted of an explosion which brough to the release of potassium hydroxide solution (KOH) from the…

During transfer of LH2 from a 200,000 gallon (760 m3) storage vessel to a road trailer, loss of vacuum was detected due to a crack in the outer vessel. The crack was located below an elbow of the…