- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
The leak occurred on the compressor of a hydrogen testing laboratory. The location of the leak in the cylinder cap of one of the ultra-high-pressure hydrogen compressor unit. The hydrogen gas…
This incident occurred on a high-pressure hydrogen compressor part of the hydrogen production and storage unit of a testing laboratory. While in operation, a hydrogen gas detector installed above…
A leak occurred at the compression unit of the refuelling station. The employees had just initiated the normal procedure of starting up the hydrogen production equipment, and opened the three shut…
This incident event consists in two leaks occurred in the same week on a hydrogen compressor of a hydrogen refuelling station. After filling a fuel cell vehicle (FCV) with hydrogen at a compressed…
At a hydrogen production facility, the hydrogen compressor used to store hydrogen at approximately 20 MPa failed due to the rupture of the casing (spacer) connecting the hydraulic drive unit and…
This near-miss occurred at a company producing compressed gas bottles according to customers requests. When preparing a gas mixture containing oxygen and nitrogen, by mistake hydrogen was added,…
During a leak check of a flash point material testing chamber, the chamber was inadvertently over-pressurised with GH2. The glass port in the door burst, causing damage to the chamber and to the…
The released occurred at a T-coupling small of a small pipe (possibly around 6 mm in diameter) in a gas storage system consisting of 40 vertical steel cylinders of 50 l each in a container. At the…
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.