- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
A continuous venting of hydrogen from a LH2 tanker occurred during highway transportation. Trailer delivered at test site and vacuum pressure checked to be less than 1 micron. The tank pressure…
Early in the morning a hydrogen tube trailer experienced a tire fire and pulled onto the road shoulder. The driver attempted to extinguish the fire with the fire extinguisher on the vehicle. Heat…
A CGH2 tube trailer-tractor was travelling to deliver hydrogen to a customer, when a fire developed on right side of the tractor around the rear of the hood and passenger side door. Very quickly…
The trailer experienced a tire/wheel fire at the rear of the tube trailer. The fire deteriorated the hand valve packing on one of the tube causing a slow leak of hydrogen. The trailer consisted of…
A tube trailer was driving on a highway, when the drivers noticed in the back camera smoke coming from the rear of the vehicle. After stopping the vehicle on the shoulder, they discovered a fire…
A tube trailer was returning to base after delivery of gaseous hydrogen. It went off road shearing off rear valves and manifolds and released 2000 cu ft of hydrogen [Zalosh and Short, 1978]
An empty fuel cells and hydrogen bus out of service was returning to the refuelling station, when it collided with a low bridge. This resulted in the rooftop hydrogen tanks being sheared off. The…
[Note HIAD validator: this an incident where a hydrogen system was affected, as effect of the initiating event, overpressure of LH2 tank with helium, but it is not a LH2 incident]. The second…
During the warm-up phase of a large liquid hydrogen sphere, the annular space was over-pressurised and perlite insulation was expelled through the evacuation nozzle and the burst diaphragm. Air…
This event with minor hydrogen releases occurred during the operation of a hydrogen compressor. The compressor was part of a mobile hydrogen production unit and connected to a bundle of cylinders…
A stainless steel manifold ruptured during experimental operation. The manifold was made of stainless steel and had a diameter of three inch (7. 5 cm). The hardware was off-the-shelf, slightly…
During the pump operation of a liquid hydrogen tanker, the vent valve was opened rapidly and the hydrogen detonated above the vent stack. The rapid valve opening was aimed at initiating a good…
A mixture of hydrogen and diesel leaked and ignited on a desulphurisation unit of a refinery. The emergency plan was initiated few minutes later. The unit was shut down and the leak was stopped.…
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.