Skip to main content

Ball of Fire from Hydrogen Fuel Cell Forklift Flashes and Quickly Extinguishes

Ball of Fire from Hydrogen Fuel Cell Forklift Flashes and Quickly Extinguishes

Incident Date
When Incident Was Discovered
Severity
Incident
Was Hydrogen Released?
No
Was There Ignition?
Yes
Equipment
Damage and Injuries
Probable Cause
Describe the incident, including corrective steps taken and their result.

A fuel cell forklift operator stated that he observed a "ball of fire" coming from the left side of the forklift that seemed to flash and extinguish. Investigators found no external signs of a fire, but the forklift would not start. The fuel cell power pack access panel was removed to enable investigators to search for any internal signs of a fire. Some areas inside the fuel cell stack appeared to have experienced an electrical arc or some type of overheating. All connections were verified to be tight and secure. The internal fuel cell stack circuit board cover was then removed, and the circuit card on top of the stack also showed signs of overheating. After the fuel cell stack circuit board was removed, a broken drill bit was discovered on top of the fuel cell stack plates.

Evidently, the drill bit was jostled around when the forklift was operated, causing a spark and fire inside the fuel cell stack that burned the circuit card. It is unclear how the drill bit got where it was on top of the fuel cell stack plates. Records indicated that there had not been any maintenance performed on this fuel cell pack that would require drilling. In addition, an inventory check of technician tools used for fuel cell stack assembly accounted for all drill bits.

Lessons Learned

It appears that this was an isolated event caused by human error. The lessons learned are: (1) to caution workers to maintain their focus during fuel cell stack assembly, (2) to require verification that all tools and spare parts are accounted for prior to closing up the system, and (3) to review quality control procedures and assembly procedures with an eye toward improvement.

Key:

  • = No Ignition
  • = Explosion
  • = Fire
Hydrogen Incident Summaries by Equipment and Primary Cause/Issue
Equipment / CauseEquipment Design or SelectionComponent FailureOperational ErrorInstallation or MaintenanceInadequate Gas or Flame DetectionEmergency Shutdown ResponseOther or Unknown
Hydrogen Gas Metal Cylinder or Regulator 3/31/2012
4/30/1995
2/6/2013
4/26/201012/31/1969  3/17/1999
11/1/2001
12/23/2003
Piping/Valves4/4/2002
2/2/2008
5/11/1999
4/20/1987
11/4/1997
12/31/1969
8/19/1986
7/27/1991
12/19/2004
2/6/2008
10/3/2008
4/5/2006
5/1/2007
9/19/2007
10/31/1980
2/7/20091/24/1999
2/24/2006
6/8/1998
12/31/1969
2/7/2009
9/1/1992
10/31/1980
10/3/2008 
Tubing/Fittings/Hose 9/23/1999
8/2/2004
8/6/2008
9/19/2007
1/1/19829/30/2004
10/7/2005
 10/7/2005 
Compressor 10/5/2009
6/10/2007
8/21/2008
1/15/2019
  10/5/20098/21/2008 
Liquid Hydrogen Tank or Delivery Truck4/27/198912/19/2004
1/19/2009
8/6/200412/31/1969 1/1/197412/17/2004
Pressure Relief Device7/25/2013
5/4/2012
1/15/2002
1/08/2007
12/31/1969    
Instrument1/15/20193/17/1999
12/31/1969
2/6/2013
  11/13/73  
Hydrogen Generation Equipment7/27/1999  10/23/2001   
Vehicle or Lift Truck 7/21/2011    2/8/2011
12/9/2010
Fuel Dispenser 8/2/2004
5/1/2007
6/11/2007
9/19/2007
 2/24/2006
1/22/2009
   
Fuel Cell Stack      5/3/2004
12/9/2010
2/8/2011
Hydrogen Cooled Generator   12/31/1969
2/7/2009
   
Other (floor drain, lab
anaerobic chamber,
heated glassware,
test chamber,
gaseous hydrogen
composite cylinder,
delivery truck)
 11/14/1994
7/21/2011
7/27/1999
6/28/2010
8/21/2008
12/31/1969
3/22/2018
  6/10/2019
  • = No Ignition
  • = Explosion
  • = Fire