Skip to main content

HIAD Facility - Storage Medium: Liquid


An explosion occurred during tensile tests of metals in a liquid hydrogen vessel. efforts were made to prevent air from entering by using a flexible top skirt designed to allow for movement of the…

A LH2 tank exploded causing injury and damage when hot wire sensors were used in tank after purging. [Ordin, NASA (1974)]

After cooldown of a LH2 system, the operator noticed cold gas issuing from a small hole in a flexible section of the vent line. Subsequent examination revealed that a deflagration had taken place…

During general repair and equipment replacement on a liquid oxygen-liquid hydrogen Saturn test facility, a section of the 24-inch GH2 vent line ruptured. An explosion occurred causing extensive…

The incident occurred at a facility performing material tensile tests in hydrogen at cryogenic temperatures. At the end of the test, the cryostat top was removed. In order to increase vaporization…

A liquid hydrogen system exploded and burned during fill operations due to inadequate purging after the previous operation. [Ordin, NASA (1974)]

The event terminated an unmanned flight. One of the goals of the mission was to gain experience from re-firing engines in space. It was important to understand better the behaviour of the liquid…

The last flight of the Space Shuttle Challenger ended 73 seconds after the launch in an explosive burn of hydrogen and oxygen propellants that destroyed the External Tank and exposed the Orbiter to…

While preparations were being made for a LH2 turbopump test, an explosion occurred above the test cell. Major damage was caused throughout the test facility. A short duration fire caused minor…

A special test was being executed to evaluate a high-pressure fuel turbo-pump lift-off seal. During the test, an open-air explosion took place on the test stand. There were no injuries, but non…

[Note HIAD validator: this an incident where the hydrogen systems were invovled as effects of the initiating event. There is nevertheless and addtional possible contribution by hydrogen…

After completion of a process using hydrogen an explosion occurred in the vicinity of the vent stack. Cold hydrogen gas was being vented into the atmosphere for about 45 minutes. The weather was…

A common vent system was used to connect vent lines from liquid hydrogen storage vessels to the vent stack (which was lit flaring the gas). Low order detonations were observed around the vent…

The incident occurred when filling a gaseous tube trailer from a liquid hydrogen stationary storage system. The liquid hydrogen cryogenic pump shaft malfunctioning caused a series of explosions…

During a test of an 8 foot scale tank loaded with LH2, the tank burst at 77 psi (ca. 5. 3 bar) destroying the test installation. No fire or explosion occurred and the area control was successfully…

A tank of liquefied hydrogen felt down in a chemical plant. The tank, containing 100 m³ of liquid hydrogen, was installed on a concrete plate, which failed. The hydrogen started leaking from the…

Following loading of propellant run tanks, the insulation jacket (filled with perlite) on the conmon vent and pressurisation line for the LH2 storage tank burst. [Ordin, NASA (1974)]

A dual phase hydrogen tanker was expected to refill the storage of a refuelling station for buses. Due to the failure of the a bolt of the tanker pump, the refuelling could not take place. This…

A fire occurred on top of a vent stack attached to a LH2 vessel. The ignition source was unknown but electrical storms in the vicinity may have been responsible. The flame was extinguished by…

A LH2 trailer was delivering at a customer location. The LH2 transfer had just been terminated and the driver was ready to depressurise the trailer to remove the hose. When he started to open the…