Skip to main content

HIAD Classification of the Physical Effects: Hydrogen Release And Ignition


The safety cabinet with compressed hydrogen was located in a laboratory and used to supply hydrogen to an experimental facility. The safety cabinet was equipped with exhaust extraction. Due to a leak…

A stainless steel manifold ruptured during experimental operation. The manifold was made of stainless steel and had a diameter of three inch (7. 5 cm). The hardware was off-the-shelf, slightly…

During the pump operation of a liquid hydrogen tanker, the vent valve was opened rapidly and the hydrogen detonated above the vent stack. The rapid valve opening was aimed at initiating a good…

A mixture of hydrogen and diesel leaked and ignited on a desulphurisation unit of a refinery. The emergency plan was initiated few minutes later. The unit was shut down and the leak was stopped.…

A number of hydrogen-filled balloons burst into flames at a secondary school. About 1,500 small balloons to be used for the opening ceremony of a sport event exploded unexpectedly and caught fire at…
Hydrogen explosion on NPO "Azot" in Rovno, Ukraine.
The incident took place in compression room of methanol synthesis manufactory. As a result of the destruction of a pipe, a mixture of pressurised gases (mostly hydrogen) filled compression room and…
An explosion at a hydrogen recovery plant resulted in the injury of 10 people.
An explosion without fire or gas emission occurred in the washer of the catalyst activation unit. The unit was stopped for maintenance : 3 external employees were checking the washer. The explosion…
An explosion occurs during testing of the hydrogen feeding of an engine in the Spatial Agency Centre.

A series of explosions occurred in a converter where hydrogen is extracted from ammonia. A fire occurred as a result of the incident.

The explosion occurred at a ramjet engine of an aerospace testing centre. In order to carry out an airtight test on the engine, a pressure gauge was connected, the bolts on the hydrogen supply pipe…
An explosion and fire occurred on a reformer at a fertiliser plant. Source of ignition was auto ignition or electric motor.
A vapour explosion, followed by a fire, occurred at a drier in a plant making titanium sponge. When titanium containing water was put into the drier, it came to contact with the edge of the…

Failure of 400 mm pipe at 1. 7 MPa caused release and ignition took place 10 seconds later.

A runaway chemical reaction happened in a reactor containing methanol and a substance to be hydrogenated. A large quantity of hydrogen was released; a balloon containing a borohydride exploded.…

The incident occurred at a storage tank of an organic chemical plant. The storage tank was containing cyclo-dodecane (C12H24, melting point: 60 °C), and a tank trucks was being filled at the…

The explosion occurred while restarting the ammonia reactor. Synthetic gas (70% H2) was released at the flange of the relief valve of the turbo-compressor. The explosion was followed by a jet fire.…

This event occurred at the accelerator bubble chamber facility. During final stages of chmaber cooldown and its loading with LH2 (95% fill, about 95 gallons), an explosion and fire occurred…

During initial resting at a liquid hydrogen bubble chamber facility, an explosion occurred shortly after opening a high pressure hydroger line. The explosion was assumed to have taken place in the…