Skip to main content

HIAD Causes: Human Factors


The explosion occurred while maintenance personnel were grinding a high-pressure injection (HPI) pipe, which had been recently cut at approximately 18 inches from the nozzle connecting the HPI pipe…
The fire broke out in the acid etching tank of the ferric chloride manufacturing unit of a SEVESO-classified chemical plant. In this tank, the attack reaction of the iron metal with hydrochloric acid…
The incident occurred outside a fuel cells manufacturing facility. While preparing for transfer of liquid hydrogen from tanker truck to a stationary storage tank, a release of hydrogen occurred,…
Three workers were working in the sulphur recovery unit (SRU), trying to restore the hydrogen flow. The workers were trying to isolate the cause of a flow problem: hydrogen was entering the…

A truck transporting hydrogen and oxygen cylinders collided with a passenger vehicle at an intersection and overturned, causing all cylinders containers to fall onto the road. Gas leaked from four…

The event occurred in a bus garage when carrying out the purging process of the hydrogen cylinders. This process was executed via an electronic control system, but it was found that one cylinder…
In a metal production company, a leak occurred on valve of a hydrogen line. A new valve was ordered. Almost one month later workers arrived on site to replace the valve. After one hour they heard an…
Following the first flight of the Montgolfier brothers, the first severe accident with hydrogen on a Montgolfier-balloon occurred in 1785, when trying to cross the Channel from France to England. Two…
The event occurred in a desulphurisation unit for heavy oil (hydro-cracking, Isomax process). The hydrogen released from one of the heat exchangers where the feed gases are pre-heated by the reactor…
A pallet containing 9 hydrogen cylinders was damaged during the operation of unloading the cylinders trailer by means of a forklift. A 2 mm wide crack, caused by the fork, was observed on a flexible.…

The burst disc activated prematurely on a small hydrogen tube trailer. The pressure at which the activation occurred was between 80 and 100 bar (1200 and 1500 psig). The design activation pressure…

A 50-litre standard hydrogen gas cylinder was temporarily placed and used in a laboratory. The hydrogen gas was used for a flame ionization detector (FID) in gas chromatography (GC) instrument. The…
The tanker crashed into the guardrail on a ring ramp leading to a highway. The tanker overturned, and the tank unit plunged more than 20 meters onto a road below. Witnesses reported multiple…
A tanker carrying liquid hydrogen overturned without rupturing. Traffic on an interstate highway was closed throughout the afternoon and evening.
The event occurred in a university research building dedicated to the study of the take-off of space launchers . An operator gave the alarm during the hydrogen pressure pre-setting phase. he had seen…
The fire took place during maintenance works in one out of the three gas extractors of the coke process line. Main cause was displacement of a flange which allowed the entrance of flammable mixture…

During a transfer of liquid hydrogen from a commercial tanker to a stationary receiving vessel, a leak developed in the bayonet fitting at trailer-vessel connection. The leak produced a hydrogen…

This accident occurred at the unit producing synthetic adhesives by adding hydrogen to petroleum resin under high temperature and pressure. Hydrogen was added to the reaction via a supply pipe at the…

A tube trailer transporting three compressed hydrogen tubes had to perform an emergency manoeuvre to avoid an oncoming vehicle which crossed the centre line. The trailer crashed into a traffic…

A large hydrogen gas leak from a dewar resulted when bolts holding fitting the top of the tank was loosened. The fitting contained instruments. On loosening the third bolt, hydrogen gas excaped…