Skip to main content

HIAD Nature of the Consequences: Leak No Ignition


In a plastics production plant, a pallet containing 7 cylinders of nitrogen and 1 cylinder of hydrogen fell from a truck traveling in a logistics zone. The driver stopped the vehicle, cut off the…
A gas leak containing hydrogen and hydrogen sulphide (H2S) occurred at the upper isolation valve located at a high-pressure separator (300 bar). This unit spearates the process gases from process…
A compressed gas spherical vessel failed along the along the weld, releasing the whole content, consisting in a H2-CH4-rich mixture (54%, 26%). The cause was stress corrosion accelerated by hydrogen.
Three workers were asphyxiated when argon and hydrogen gas leaked from pipes they were installing on an aromatics plant being built on a cracking complex.

A dispenser hose failed at a hydrogen refuelling station. It ruptured with a sidewall burst, approximately 30 cm from the crimped end fitting. The hose had experienced a total of aproximately 300…

Hydrogen was accidentally released into the compressor room of a hydrogen refuelling station. The fixed gas detector in the compressor room issued a value of 48% vol. of he Low FLammability Level,…

In a petrochemical plant, a gas mixture at 270 bar made of 75% hydrogen (H2) and 25% methane (CH4) leaked through the bottom valve of a dryer of a resin production unit. After detection of the leak,…
One of the two dispensers at a refuelling station for buses shutdown at a refuelling station. The dispenser company were called and confirmed there was an issue with the dispenser. The station…
The release occurred on a pipeline inside a steam cracking unit located between two hydrogenation units. The gaseous mixture transported through this line (2" diameter, 30 bar, 40°C) was composed of…

The event occurred during the fuelling process of the primary fuel tank of the core stage of a moon rocket. The initial slow-filling phase was terminated, and personnel had just started the fast…

A hydrogen leak occurred in a CO (carbon monoxide) - hydrogen separation cold box of an acetic acid plant.

The hydrogen leak occurred on a lorry travelling on a motorway. According to Highways England the vehicle was carrying nine cylinders of gas, one of which had a crack and was leaking. The only way to…

Hydrogen as carrier gas was provided to a reactor gas chromatograph by several compressed hydrogen bottles. The bottles emptied rapidly, but the loss of carrier gas could only be detected when the…

The leak occurred at an heat exchanger of the hydro-isomerisation unit of a refinery. Following the observation of a pressure drop between two heat exchangers, controls were carried out on site. A…

This incident occurred at a 70MPa hydrogen refuelling station. After completing a filling test, the pressure in the filling hose suddenly dropped. A worker heard the hissing sound of a hydrogen…

The event occurred in a bus garage when carrying out the purging process of the hydrogen cylinders. This process was executed via an electronic control system, but it was found that one cylinder…
The event occurred at a pit furnace for metal component treatments. The hydrogen feed system for the furnace developed a leak, located on the hydrogen dryer inside a shack attached to a building. The…
The station was storing 6,000 litres of liquid hydrogen in ten tanks. Rescue services were alerted and the station's activity is interrupted. The leak was stopped by closing the valves. According to…
A pallet containing 9 hydrogen cylinders was damaged during the operation of unloading the cylinders trailer by means of a forklift. A 2 mm wide crack, caused by the fork, was observed on a flexible.…

The burst disc activated prematurely on a small hydrogen tube trailer. The pressure at which the activation occurred was between 80 and 100 bar (1200 and 1500 psig). The design activation pressure…