Skip to main content

HIAD Classification of the Physical Effects: Unignited Hydrogen Release


A tube trailer was returning to base after delivery of gaseous hydrogen. It went off road shearing off rear valves and manifolds and released 2000 cu ft of hydrogen [Zalosh and Short, 1978]

This event with minor hydrogen releases occurred during the operation of a hydrogen compressor. The compressor was part of a mobile hydrogen production unit and connected to a bundle of cylinders…

A hydrogen leak was detected in the dispenser pump causing the alarm to sound.
During a filling at a hydrogen refuelling station, the station was shut down due to a gas detection. The leak was extremely small and difficult to locate but the gas was directed upwards towards the…

After a test of a LH2 vessel, during the warm up phase, the plan was to dispose of the hydrogen through the vent system. However, a leak to atmosphere occurred. This was due to a blind flange…

A liquid hydrogen system exploded and burned during fill operations due to inadequate purging after the previous operation. [Ordin, NASA (1974)]

During a test of an 8 foot scale tank loaded with LH2, the tank burst at 77 psi (ca. 5. 3 bar) destroying the test installation. No fire or explosion occurred and the area control was successfully…

A tank of liquefied hydrogen felt down in a chemical plant. The tank, containing 100 m³ of liquid hydrogen, was installed on a concrete plate, which failed. The hydrogen started leaking from the…

This incident consisted in the dropping of a gas cylinder and the release of its content due to stress corrosion

A driver of a fuel cells vehicle terminated the refuelling and drove away without disconnecting the fueling hose from its vehicle. The breakaway of the fueling hose was supposed to open, but did…

Chlorine was released in the liquefaction unit of a chlorine electrolysis plant, due to the rupture of a pipe. During the re-start phase of an electrolysis workshop in a chemical plant, chlorine (Cl2…
The incident occurred at the recycle hydrogen compressor of a hydro-desulphurisation unit. The compressor was equipped with a suction rectifier. The drainpipe of this rectifier had been corroded…
A hydrogen leak occurred in in the cooling system of electricity generation part of the in a nuclear power plant. .

A LH2 trailer was delivering at a customer location. The LH2 transfer had just been terminated and the driver was ready to depressurise the trailer to remove the hose. When he started to open the…

A fire broke out on a transformer transforming 225,000 V into 15,000 V in a metallurgical plant. This transformer supplies electrical power the site and to a neighbouring factory. In the following…
A LH2 trailer was delivering at a customer’s site. Just after having terminated the transfer to the stationary tank approximately 13000 gallons (3500 kg) of liquid hydrogen, the pressure relief valve…

Break of pipeline in oil cracker, resulting in a continuous release in partially confined atmosphere.

A liquid hydrogen tanker was returning empty to the home terminal after delivery to a customer. At a stop, the drivers executed a visual inspection of the vehicle and noticed an accumulation of…

In a plastics production plant, a pallet containing 7 cylinders of nitrogen and 1 cylinder of hydrogen fell from a truck traveling in a logistics zone. The driver stopped the vehicle, cut off the…
A gas leak containing hydrogen and hydrogen sulphide (H2S) occurred at the upper isolation valve located at a high-pressure separator (300 bar). This unit spearates the process gases from process…