Skip to main content

HIAD Specific Application Supply Chain Stage: Hydrogen As Feedstock


A fire started on the primary hydrogenation reactor of a chemical plant synthesizing alcohols and acids by reactions between olefins and a H2 / CO gas mixtures. The alcohols are synthesised in 3…
The event occurred on vent stack of an ammonia synthesis unit. The release of the gas was more specifically on the water purge line or the hydraulic guard of the vent stack. The process gas…

The event occurred at a high-temperature heat of at a benzene manufacturing plant using a dealkylation reaction. High-pressure hydrogen leaked from a flange of the heat exchanger, during start-up…

The incident occurred at a university facility, in the premises of a spin-off company. A worker was checking the hydrogen pressure by opening the main valve on a hydrogen cylinder, when hydrogen…

In a chemical plant, a fire broke out on a hydrogen column of an ammonia manufacturing unit. The internal security service extinguishes the fire with powder and nitrogen injection. The unit was…
In a fertilizer manufacturing plant, a gas leak occurred at an ammonia unit heat exchanger located in a ventilated area outside. The operator partially stopped the unit, set up steam hoses and…
This accident occurred at the unit producing synthetic adhesives by adding hydrogen to petroleum resin under high temperature and pressure. Hydrogen was added to the reaction via a supply pipe at the…
A hydrogen leakage occurred in the ammonia workshop of a plant manufacturing nitrogen products and fertilizer (classified SEVESO high threshold). It was detected by an operator in charge of safety…
In a chemical plant , a process gas leak (4% ammonia and 88% hydrogen) occurs during a purge operation. The cloud of gas ignites and explodes. An employee is killed.
Furnace tube leak caused excessive heat on H2 tube causing rupture [Zalosh and Short, 1978]

Compressed hydrogen escaped from reactor due to faulty gasket [Zalosh and Short, 1978]

In an ammonia production unit, a 350-bar leakage of synthesis gas (ammonia + hydrogen) occurred in the compressor room. The leak was the result of the failure of a weld on a line (2") at the outlet…
In a fertilizer manufacturing plant, during his inspection round, an operator detected a hydrogen leak at a flange of an exchanger located between the conversion and decarbonisation stages of the…
During the start-up of a propylene hydrogenation reactor, very high temperatures were generated in the catalyst bed. At the time, propylene and hydrogen were being fed to the reactor which contained…

A small fire occurred at the vent stack of an ammonia processing unit in a plant producing fertilisers and other nitrogen-based chemicals. A safety shutdown procedure of the ammonia processing…

There was a small leak of syngas (a mixture mainly consisting of hydrogen and carbon monoxide) resulting in a localised fire at a bolted flange joint on the outlet carbon steel pipework of the High…

The incident occurred at the ammonia synthesis unit of a production plant of fertilizers (Seveso III upper tier), during the operation of start-up. The unit was restarting, when a pipe carrying…

Following a trip caused by the safeguarding of an ammonia production line, the syngas released into the atmosphere and ignited.
The event occurred while re-starting the ammonia production unit after a technical stop, a synthesis gas (50% hydrogen, 17% ammonia, methane and nitrogen) leak ignited on a flange located just after…