- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
A large quantity of hydrogen was being vented to atmosphere during pre-chill operations. Normal pre-cooling time was about 45 minutes, but due to technical problems, the pre-cooling continued for…
The event occurred during the testing of a LH2 pump. When the air turbine pump drive was initiated, the cool down of pump loop was underway, and the speed had increased to design condition and…
An explosion occurred during tensile tests of metals in a liquid hydrogen vessel. efforts were made to prevent air from entering by using a flexible top skirt designed to allow for movement of the…
During a test in which GH2 was driving gas, an explosion occurred in the test section. The drive chamber was over-pressurized to 3500 psi (240 bar). The test section failed; windows designed for a…
The event terminated an unmanned flight. One of the goals of the mission was to gain experience from re-firing engines in space. It was important to understand better the behaviour of the liquid…
While preparations were being made for a LH2 turbopump test, an explosion occurred above the test cell. Major damage was caused throughout the test facility. A short duration fire caused minor…
A special test was being executed to evaluate a high-pressure fuel turbo-pump lift-off seal. During the test, an open-air explosion took place on the test stand. There were no injuries, but non…
[Note HIAD validator: this an incident where the hydrogen systems were invovled as effects of the initiating event. There is nevertheless and addtional possible contribution by hydrogen…
An explosion occurred during calibration of engine. The equipment was covered by a shed and when the valve was operated allowing hydrogen gas to flow through the engine, the gas ignited. The…
During a test of an 8 foot scale tank loaded with LH2, the tank burst at 77 psi (ca. 5. 3 bar) destroying the test installation. No fire or explosion occurred and the area control was successfully…
Following loading of propellant run tanks, the insulation jacket (filled with perlite) on the conmon vent and pressurisation line for the LH2 storage tank burst. [Ordin, NASA (1974)]
At a rocket engine testing facility, a combustion experiment of the pre-burner (gas generator for driving the turbopump) was being conducted, before testing the turbopump. The pre-burner is the…
During preparation of a spacecraft LH2 tank in an environmental test chamber, a liquid hydrogen fire occurred in the chamber. The tank was being "topped off" at the time. Damage was…
This incident happened during a test of a hydrogen engine prototype vehicle, equipped with on-board liquefied hydrogen storage. The hydrogen gas leaked from a hose joint of a flexible pipe in the…
During a cryo-irradiation testing, a Dewar failed or leaked hydrogen into the atmosphere, causing a fire. The Dewar's were nitrogen-walled LH2 vessels to contain metal samples for testing. In…
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.