Skip to main content

HIAD Facility - Location Type: Unknown


Release from a compressed storage of an optics component plantThe leak was observed on the hydrogen storage consisting of 19 racks of 16 cylinders each. Rescue teams set up a security perimeter and a…
Leakage of gas from blow-off pipe for depressurization while filling hydrogen in cylinder.

The incident occurred at a plant manufacturing polymer batteries, audio and GPS systems. As consequence of the great tohokyu earthquake and tsunami, a pipe of a hydrogen tank started leaking,…

A hydrogen tank exploded and caught fire at a chemical plant.

Hydrogen caused an explosion at a power plant, killing two people and injuring 13 others. The station was subsequently shut down. The cause of the explosion was not reported. At first, sources…

A hydrogen explosion occurred on a furnace in a company of copper metallurgy. The incident occurred at the end of the production cycle, when the furnace bell is lifted at the end of the cooling…

Test facility H2 vent line exploded destroying about 150 feet of line. The flare stack was on at the time. [Ordin, NASA (1974)]

The fire took place during maintenance works in one out of the three gas extractors of the coke process line. Main cause was displacement of a flange which allowed the entrance of flammable mixture…

During a transfer of liquid hydrogen from a commercial tanker to a stationary receiving vessel, a leak developed in the bayonet fitting at trailer-vessel connection. The leak produced a hydrogen…

This accident occurred at the unit producing synthetic adhesives by adding hydrogen to petroleum resin under high temperature and pressure. Hydrogen was added to the reaction via a supply pipe at the…

A large hydrogen gas leak from a dewar resulted when bolts holding fitting the top of the tank was loosened. The fitting contained instruments. On loosening the third bolt, hydrogen gas excaped…

The incident occurred when refuelling with hydrogen a fuel cell forklift. The hydrogen was provided by a mobile refuelling station. The filling of a second forklift of the day had just begun, when…

A leak occurred at the fill valve of a LH2 vessel. With the tank pressure at about 100 psi a leak was noticed. The area was cleared and the vessel was emptied by remote controls. [Ordin, NASA…

An explosion occurred in the transformation section of a fertiliser manufacturer, resulting in 8 deaths and 3 injuries. A leak in the secondary pipeline of the 1st conversion system, and caused the…

The event occurred during a pressure testing of a LH2 pump discharge system. A weld joint failed at an internally tied bellows. The weld failed at 1100 psi (ca. 76 bar) while the test pressure…

A potentially explosive situation was reported by safety inspectors at a nuclear waste tank. The waste slurry had formed a thick crust which was trapping hydrogen being continuously generated…

During a welding operation on a LH2 fill line it was discovered that LH2 was still in the tank although it should have been drained. Hence the potential for a major explosion existed. [Ordin, NASA…

An operator noted a loose tube sheet flange stud on a high temperature, high pressure heat exchanger in an hydrodealkylation unit. The stud was found to be cracked through. Analysis proved to be made…
An oil leak in a hydrogen compressor was identified in the end of Aug 2015 by a technician performing regular maintenance on the compressor. The oil leak had caused a contamination of the entire…
A hydrogen pipe burst at a semiconductor plant injuring 1 person