Skip to main content

AWST - Technology: Low Temperature Electrolysis (LTE)


method for screening HER/OER electrocatalysts using fully immersed electrodes covered with electrocatalyst. Optimized for usage in alkaline solutions with high loading of electrocatalysts up to 4…

The harmonization of testing protocols for proton exchange membrane (PEM) electrolyzers is essential for ensuring accurate and reliable performance assessments and accelerating the development of…

Proton exchange membrane (PEM) electrolysis for hydrogen production is a rapidly growing industry. Many universities, laboratories, and companies are devoting time and resources to develop…

While the number of publications in the PEM water electrolysis community increases each year, no common ground concerning reference hardware (test cells and test bench) and testing protocols has…

A procedure for measuring the hydroxide conductivity of an anion exchange membrane (AEM). A four-electrode In-plane conductivity is measured as a function of relative humidity (RH). The SOP was…

A procedure for the measurement of gas permeability of an anion exchange membrane (AEM). During the course of the electrochemical reaction, low gas permeation of hydrogen and oxygen through the…

This SOP describes experimental methods for characterizing the chemical and mechanical stability of anion exchange membranes (AEMs) exposed to oxygen saturated concentrated alkaline aqueous…

A procedure for ex-situ evaluation of chemical (alkaline) stability of anion exchange membranes (AEM). The IEC and ionic conductivity of an AEM is measured before and after being heated (typically…

This study presents the validation of protocols for measuring ion exchange capacity (IEC) and alkaline stability of anion exchange membranes (AEMs) for low-temperature water electrolysis. While…

Defines a standard set of definitions, metrics, units, and conventions for low temperature electrolysis (LTE). The goal is to ensure that the literature is consistent from research group to…

This document introduces proposed accelerated stress testing (AST) protocols for assessing the performance degradation of water electrolyser (WE) stacks. These stacks play a crucial role in…

This procedure is a general characterisation method that is used in research and development of the LTWE single cells. It addresses to the user as an experimenter performing on LTWE single cells…

The purpose of this generic testing procedure is to characterise the performance of a low-temperature WE cell or stack in terms of polarisation curves at specified operating conditions. The…

This report entitled EU harmonised terminology for hydrogen generated by electrolysis is prepared under the FWC between JRC and FCH2JU. It is the result of a collaborative effort between European…

This report was prepared under the Framework Contract between the Joint Research Centre (JRC) and the Fuel Cells and Hydrogen second Joint Undertaking (FCH2JU). This document is the result of a…

Electrochemical Impedance Spectroscopy (EIS) is a suitable and powerful diagnostic testing method for PEMWE (polymer electrolyte or proton exchange membrane water electrolysis) cell because it is…

Ex-situ measurement of the compressibility of Gas Diffusion Layer (GDL) materials for use as electrode materials in applications such as fuel cells, electrolyzers, and batteries. The SOP was…

A procedure for measuring the ion exchange capacity (IEC) of an anion exchange membrane (AEM). This is done via a titration method (automated or manual). The SOP was prepared by Yushan Yan,…

A procedure for measuring the ion exchange capacity (IEC) of a proton exchange membrane (PEM). The SOP was prepared by Kelly M. Meek.

As ever-increasing amounts of renewable electricity enter the energy supply mix on a regional, national and international basis greater emphasis is being placed on energy conversion and storage…