Skip to main content

Rupture of a heat exchanger in a refinery, due to hydrogen attack (883)

This data is from the European Hydrogen Incidents and Accidents database HIAD 2.1, European Commission, Joint Research Centre.

Rupture of a heat exchanger in a refinery, due to hydrogen attack

A petroleum refinery experienced a catastrophic rupture of a heat exchanger in the catalytic reformer / naphtha hydrotreater unit. The heat exchanger catastrophically ruptured because of High Temperature Hydrogen Attack. Highly flammable hydrogen and naphtha at more than 500 degrees Fahrenheit (260ºC) were released from the ruptured heat exchanger and ignited, causing an explosion and an intense fire that burned for more than three hours. The accident fatally injured seven employees (one shift supervisor and six operators) who were working in the immediate vicinity of the heat exchanger at the time of the incident.
Event Date
April 2, 2010
Record Quality Indicator
Classification of the Physical Effects
Nature of the Consequences
Cause Comments
The INITIATING CAUSE was carbon steel degradation and seal break due to high temperature hydrogen attack (HTHA). The reports speak of self-ignition of the naphtha/H2 mixture. Because of the refinery’s long history of frequent leaks and occasional fires during this start-up activity, the CSB considered this work to be hazardous and non-routine.
Facility Information
Application Type
Application
Naphtha Hydrotreater unit
Specific Application Supply Chain Stage
Components Involved
heat exchanger PREHEATING THE NAPHTA
Storage/Process Medium
Location Type
Location description
DESCRIPTION OF THE FACILITY The heat exchangers are used to preheat process fluid before it enters a reactor of the Naphtha Hydrotreater unit.
Operational Condition
Pre-event Summary
The workers were in the final stages of a start-up activity to put back in-service following cleaning a bank of heat exchangers.
Consequences
Number of Injured Persons
0
Number of Fatalities
7
Lessons Learned
The Chemical Safety and Hazard Investigation Board (CSB) has issued a report which makes recommendations, summarized below, to the various recipients. To the Refinery the recommendation was to implement a process safety culture program that will assess and continually improve any identified process safety culture issues. Moreover, since it is difficult to detect HTHA damage by inspection, an inherently safer design would be better approach to prevent HTHA. This design approach should especially focus on heat affected zones around welds, because HTHA occurs most likely there. The following two aspects related to management of operations: (1) Gradual changes to operating conditions (e. g. heat exchanger fouling or catalyst deactivation) may lead to an accidental breach of operating limits. (2) Abnormal (transient) operating conditions (e. g. startup, fouling, shutdown, etc) can create major process safety hazards. Finally, an important technical lesson could be drawn, regarding the Nelson Curve; this is a chart used in the petroleum and chemical industries to define safe operating limits (temperature vs. hydrogen partial pressure) for steel equipment, preventing High Temperature Hydrogen Attack (HTHA), where hydrogen degrades the steel's microstructure, leading to potential failure. The heat exchangers materials had been chosen according to the curves. Wit the information delivered by the event, the Nelson curve for carbon steel was revised. For carbon steels and C-0. 5 Mo steels in hydrogen service, the safe operating limit should be > 28°C (50°F) and > 3. 5 bar (50 psi) below the new Nelson curve. Refinery equipment and piping susceptible to HTHA should be replaced with inherently safer materials (e. g. low Cr-Mo alloys) to mitigate the risk.
Event Nature
Release Type
Release Substance
H2, Naphta
Hydrogen Release Concentration (%)
0.00
Ignition Source
Detonation
No
Deflagration
No
High Pressure Explosion
No
High Voltage Explosion
No
Flame Type
References
References

The Chemical Safety and Hazard Investigation Board (CSB) report REPORT 2010-08-I-WA (May 2014). Available at: https://www. csb. gov/tesoro-refinery-fatal-explosion-and-fire/ (accessed June 2020)

ICHEME Lesson Learned https://www. icheme. org/media/15117/anacortes-incident-summary-02-apr-10. pdf (accessed Septmeber 2024)

Also uptaken by in H2TOOLS https://h2tools. org/lessons/rupture-refinery-heat-exchanger (accessed dec 2024)