Skip to main content

Pressure vessel failure in a chemicals plant (1045)

This data is from the European Hydrogen Incidents and Accidents database HIAD 2.1, European Commission, Joint Research Centre.

Pressure vessel failure in a chemicals plant

The vessel affected by the incident was a gas storage used for the hydro-desulphurisation process. The desulphurisation gas had high hydrogen content. The vessels had cracks in the upper transverse fillet welds at the gas inlet which caused low stress brittle fractures. The cracks had been found during the maintenance, but not fixed. This eventually caused a gas release. Approximately 2. 5 hours after that a leak was detected and reported, a first explosion occurred. As the heat exchanger explosion was facing the desulphurisation pump room, the leaking gas gathered in the pump room, under the effect of the first explosion flame. 7 seconds later, a secondary explosion occurred in the desulphurisation pump room, resulting in 3 deaths. Due to the impact of debris from the first explosion and the high temperature of the open flame, a third explosion occurred in another cracked pressure pipe.
Event Date
June 28, 2015
Record Quality Indicator
Event Initiating System
Classification of the Physical Effects
Nature of the Consequences
Cause Comments
the INITIATING CAUSE was corrosion of a welded joint, with a low brittle fracture resistance. One of the root CAUSES was a lack of maintenance and repair. Another could be attributed to lack of risk management and safety culture. The existence of the crack was known, but no action had been taken.
Facility Information
Application Type
Application
Hydrodesulphurisation process
Specific Application Supply Chain Stage
Components Involved
hydrogen tank, pump building
Storage/Process Medium
Location Type
Operational Condition
Consequences
Number of Injured Persons
6
Number of Fatalities
3
Currency
Property Loss (onsite)

100000000

Post-event Summary

three fatalities, six injured persons, and a direct economic loss of 100 million Euros.

Lessons Learned
The cracks had been found during the maintenance, but not fixed. The reasons for omitting to take action are unknown. The company will have to review inspection/maintenance/repair procedures including assessment of risks from damage and ageing effects, to avoid that a near miss evolve in an incident.
Event Nature
Release Type
Release Substance
H2, H2S (impurities)
Hydrogen Release Concentration (%)
0.00
Ignition Source
Detonation
No
Deflagration
No
High Pressure Explosion
No
High Voltage Explosion
No
References
References

Investigation report available at safehoo http://www. safehoo. com/Case/Case/Container/202104/5636635. shtml (accessed May 2023)

B. Wang et al. , Hydrogen related accidents and lesson learned from events reported in the in east continental Asia,#2023, ICHS-2023