- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
Off gassing of hydrogen from battery sources depends on battery chemistry, usage/duty cycle, age, and other considerations. The specific battery manufacturer should provide recommendations for fire prevention and mitigation in battery charging rooms as the battery itself impacts how an event would be mitigated. Adequate ventilation such that combustible mixtures cannot develop is a general…
Typically, the inner vessel material used is 304 SS and the outer vessel is a combination of 304 SS and carbon steel depending on location. 316 SS or 316L material can be used, but due to higher cost and lower strength, are typically only used for higher purity systems. Nearly all tanks manufactured today use various forms of vacuum jacketed multilayer insulation for best performance. Older…
The most common means to warm liquid or cold gaseous hydrogen is the use of ambient air vaporizers using ambient atmospheric. Other means can be through the use of electric heat or process waste heat.
The pressure regulator controls the liquid flow from the tank to the pressure build (PB) vaporizer. As the tank pressure falls, the pressure regulator opens. When the set pressure of the regulator is reached, then the regulator closes. The pressure build circuit depends largely on the required use pressure and the system house-line pressure drop, which is driven by peak flow rate, pressure,…
Yes, the pressure safety relief system on LH2 tanks is sized for the loss of vacuum condition. The spring-loaded safety valves are sized for lower demand cases such as runaway pressure build or loss of vacuum. Higher demand requirements, such as loss of vacuum combined with fire, are handled by the rupture discs and are sized for such an event.
The cleanliness of an H2 piping system is often based on end use requirements since the purity of the system may impact the end use application. Cleanliness required for end use purity is usually much greater than that required to prevent condensation or oxygen content sufficient to create a safety risk. While not required for the same safety reasons as oxygen safety, specifying a system to be…
A pressure gauge is not usually provided, as one set of devices (safety valve and rupture disc) is always online by design. If the diverter valve connecting the two sets of relief devices is in the center position, both sets are online although depending upon the design of the diverter valve, it might not allow full flow in either direction. For the secondary stack with a rupture disc and a…
As is mentioned in the question, it should always be assumed that vent stack fires will occur. The vent stack must be designed to withstand a possible deflagration and the heat from a continuous vent stack fire. The stack should also have sufficient height and be located such that thermal radiation is safe for surrounding personnel, equipment, and buildings. The codes and standards have…
Refineries and large petrochemical plants will frequently have flare systems for H2 and other flammable materials. One of the major purposes of these flare systems is to prevent a large unignited cloud from forming since that could result in an explosion hazard and large deflagration overpressures if there is a delayed ignition. However, these are in large facilities which have the…
This is a fairly common arrangement and can be acceptable if properly designed. Some considerations:
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.