Skip to main content

Belt-driven Rotary Piston Vacuum Pumps for Hydrogen Service

Belt-driven Rotary Piston Vacuum Pumps for Hydrogen Service

What are the primary design and process safety considerations when using a belt-driven rotary piston vacuum pump to handle a hydrogen/argon gas mixture? Specifically, is this type of pump generally suitable for hydrogen service, and what factors should be considered regarding potential internal ignition sources, hydrogen compatibility of pump materials (including embrittlement resistance, seals, and gaskets), and electrical classification? If only the explosion-proof motor carries an ATEX/NEC rating, rather than the entire pump assembly, does this present additional safety concerns? Additionally, rotary piston vacuum pumps commonly use hydrocarbon-based oil, such as M100, which continuously contacts the process gas during operation before being separated at the outlet. Does the use of this oil introduce any significant process safety hazards when handling hydrogen-containing gas mixtures, particularly regarding flammability or potential ignition?

The primary concern is the potential introduction of air into the vacuum system, either through a suction-side leak or a gas ballast valve, if equipped. Gas ballast valves are commonly used in rotary piston pumps to mitigate vapor condensation but may intentionally introduce air into the system. As noted in the H2Tools Vacuum Pump Best Practices, this warrants particular attention when handling hydrogen. Regardless of potential ignition sources, the formation and compression of a flammable hydrogen/air mixture should be avoided.

The hydrogen concentration in the argon mixture should also be evaluated, as lower hydrogen concentrations may reduce the flammability hazard. However, flammability should be assessed for the specific gas composition rather than assuming a particular concentration is nonflammable.

Contact between hydrogen and the M100 vacuum pump oil does not appear to present a significant concern. Hydrogen is routinely handled in certain oil-lubricated compressors, and both hydrogen and hydrocarbon-based oils require an oxidant to support combustion. In the absence of oxygen or another oxidant, contact between the two would not be expected to create a combustion hazard. The manufacturer's oil specifications should nevertheless be reviewed for compatibility with the operating conditions.

At the relatively low pressures and temperatures anticipated, hydrogen-related material degradation may be less of a concern. However, a preliminary review of the pump's wetted components, seals, and gaskets is recommended.

The motor and associated electrical equipment should also be suitable for the applicable hazardous-area classification. Where an ATEX-rated motor is required for a hydrogen atmosphere, a Group IIC rating is appropriate (e.g., Ex db IIC T4 Gb), subject to the installation requirements.

Overall, our primary recommendation is to focus on preventing air ingress and verifying that the pump configuration, materials, and electrical equipment are suitable for the intended hydrogen service. Contact between hydrogen and the pump oil appears to be a secondary concern compared with the potential formation of a flammable mixture within the pump.

FAQ Category
FAQ Keyword
Submission Year
2026
Month
11