- Home
-
Resources
- Center for Hydrogen Safety
- Hydrogen Fuel Cell Codes and Standards
- Paper & References
- Web-based Toolkits
- Workforce Development

- Contact
- About H2Tools
PUBLICATION · Technical Report
The Hydrogen Safety Panel was tasked with conducting work under the project “Hydrogen Safety Panel Review of Department of Energy’s Fuel Cell Projects,” through memorandum purchase order DCO-0-40618-01 with the National Renewable Energy Laboratory using American Recovery and Reinvestment Act (ARRA) funding. Panel members reviewed project safety plans, conducted safety review site visits for selected projects, and prepared safety evaluation reports for the sites visited that included safety recommendations for the project teams.
PUBLICATION · White Paper
In developing a 70 megapascal (MPa) fueling infrastructure, it is critical to ensure that a vehicle equipped with a lower service pressure fuel tank is never filled from a 70 MPa fueling source. Filling of a lower service pressure vehicle at a 70 MPa fueling source is likely to result in a catastrophic event with severe injuries or fatalities. The Hydrogen Safety Panel recommends that DOE undertake a two‐step process to address this issue.
PUBLICATION · Journal Article
The broad use of hydrogen as an energy carrier to tackle the issue of climate change is unavoidable. The emerging hydrogen economy poses new problems to be solved to ensure a level of safety in hydrogen technologies and infrastructure comparable to that for today’s fossil fuels. The pressure of onboard hydrogen storage in early-market
PUBLICATION · Research Paper
Large-scale deflagration and detonation experiments of hydrogen and air mixtures provide fundamental data needed to address accident scenarios and to help in the evaluation and validation of numerical models such as the AutoReaGas code (used by Mitsubishi Heavy Industries, Ltd). Several different experiments of this type were performed. Measurements included flame-front time of arrival (TOA) using ionization probes, blast pressure, heat flux, high-speed video, standard video, and infrared video.
PUBLICATION · Technical Report
Sodium chloride and four or five other particulate materials have been used successfully as fire suppression agents for specific combustible metal fires. The certification testing and National Fire Protection Association recommendations for using these suppression agents are summarized here. The sodium chloride based agent and ordinary sand have also been used in some sodium hydride fires, and in a sodium hydride fire test series.
We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.