Skip to main content

Document library

PUBLICATION · Technical Report

Final Report: Hydrogen Safety Panel Review of DOE Fuel Cell Projects

The Hydrogen Safety Panel was tasked with conducting work under the project “Hydrogen Safety Panel Review of Department of Energy’s Fuel Cell Projects,” through memorandum purchase order DCO-0-40618-01 with the National Renewable Energy Laboratory using American Recovery and Reinvestment Act (ARRA) funding.  Panel members reviewed project safety plans, conducted safety review site visits for selected projects, and prepared safety evaluation reports for the sites visited that included safety recommendations for the project teams.

PUBLICATION · Research Paper

Fire Safety of Hydrogen Leaks

Quenching limits of hydrogen diffusion flames on small burners were observed. Four burner types,
with diameters as small as 8 m, were considered: pinhole burners, curved-wall pinhole burners, tube
burners, and leaky fittings. In terms of mass flow rate, hydrogen had a lower quenching limit and a higher
blowoff limit than either methane or propane. Hydrogen flames at their quenching limits were the weakest

PUBLICATION · Technical Report

Safety Standard for Hydrogen and Hydrogen Systems

This document and its companion document, Safety Standard for Oxygen and Oxygen Systems (NSS1740.151996),are identified as Tier 2 Standards and Technical Requirements in the NASA Safety and Documentation Tree (NHB 1700.1 1993). The information presented is intended as a reference to hydrogen design and practice and not as an authorizing document. The words "shall" and "must" are used in this document to indicate a mandatory requirement, and the authority for the requirement is given.

Disclaimer- The documents and references herein are for information purposes only and should not be construed as endorsement by the Hydrogen Safety Panel.