Skip to main content

AWST - Technology: High Temperature Electrolysis (HTE)


A stable steam supply is required for the operation of solid oxide electrolysis cells. Heated water bubblers are the most common method due to the simplicity and inherent safety of the method,…

Proton-conducting ceramic electrochemical devices (PCCs) show promise for sustainable energy conversion, yet key challenges remain. This perspective highlights critical areas for advancing PCC…

The purpose of this procedure to perform mechanical property test for contact bonding strength and thermal cycle stability.

Published elsewhere: L. Zhou, W. Li, M.P. Brady, Z. Zeng, L. Ma, Y. Wang, S. Hu, X. Liu. Improved Assessment of Chromium Evaporation Rates in Solid Oxide Cell Balance of Plant Component Alloys.…

The purpose of this SOP is to define a standard set of definitions, metrics, units, and conventions for high temperature electrolysis (HTE). The goal is to ensure that the literature is consistent…

The purpose of this SOP is to describe a method for measurement of ionic and electronic conductivity in mixed ionic electronic conductor ceramics for intended use in solid oxide cells. The method…

The purpose of this SOP is to describe a method for evaluation of ionic transference number in mixed ionic electronic conductor ceramics intended for use in solid oxide cells. In this method,…

This study focuses on establishing a standardized dynamic operation protocol for testing Solid Oxide Electrolysis Cells (SOECs), highlighting their potential in dynamic energy applications due to…

This document outlines a test method for determining the current-voltage (I-U) characteristics of solid oxide cells and proton-conducting ceramic cells and stacks, operating in either fuel cell…

The objective of this pre-normative research (PNR) document is to present a testing procedure for establishing the energy performance of water (steam) electrolyser systems (WE systems), whether…

The objective of this document is to present testing protocols for establishing the performance and durability of high-temperature electrolyser (HTE) stacks and high-temperature steam electrolysis…

The purpose of this SOP is to describe a method for electrochemical impedance spectra (EIS) measurement of single solid oxide cells. By measuring the impedance response to frequency change,…

The purpose of this procedure to identify if any leaks are present in the system.